ブログに戻る
ハウツーガイド 2026-11-21 ToughTested 0 ビュー

ToughTested 4-Prong Navigator Tablet Head: Replacement Guide

ToughTested 4-Prong Navigator Tablet Head: Replacement Guide

Learn how to replace the ToughTested 4-Prong Navigator Tablet Replacement Head. This guide covers compatibility checks and step-by-step installation for your GPS mount.

When You Need a Replacement Navigator Head

If your ToughTested tablet mount's 4-prong head has worn out or broken, replacing just the head is often faster and cheaper than buying a whole new mount. The ToughTested 4-Prong Navigator Tablet Replacement Head is designed as a direct replacement part for compatible ToughTested mounts, so you can restore full functionality without swapping the entire system.

What to Check Before You Start

Before ordering or installing, confirm that your existing mount uses the same 4-prong interface. The replacement head is not universal—it works only with compatible ToughTested mounts that accept a 4-prong attachment.

  1. Verify mount compatibility: Check the base of your current mount for a 4-prong connector. The replacement head will only attach securely if the mount has matching prongs.
  2. Inspect the replacement head: The ToughTested 4-Prong Navigator Tablet Replacement Head features adjustable arms that hold most tablets and works with many protective cases. It also offers 360-degree rotation for flexible viewing angles.
  3. Gather tools: No special tools are required for installation. The head typically attaches with a simple push-and-turn or screw mechanism, depending on your mount design.

How to Install the Replacement Head

Once you've confirmed compatibility, follow these general steps. Specific instructions may vary by mount model—refer to your mount's manual if available.

  1. Remove the old head: Twist or unscrew the existing head from the mount arm. If it's stuck, apply gentle pressure while turning.
  2. Attach the new head: Align the 4 prongs on the replacement head with the slots on your mount. Push firmly until it clicks or screws into place. Ensure it's fully seated before releasing.
  3. Adjust for your device: Open the adjustable arms and place your tablet or GPS device inside. Tighten the arms until the device is held securely. Rotate the head to your preferred viewing angle.
  4. Test the connection: Give the tablet a gentle tug to confirm it's locked in. If it shifts, readjust the arms or recheck the head attachment.

Important Compatibility Note

The ToughTested 4-Prong Navigator Tablet Replacement Head is a dedicated replacement part. It is not designed for use with mounts that have a different prong count or attachment style. Always verify that your mount uses a 4-prong connector before purchasing.

Product Details at a Glance

関連記事

Customer Service
ホーム
商品
カート
マイページ