Back to Blog
How-to Guides 2026-11-20 ToughTested 0 views

How to Use the ToughTested Phoenix Jump Starter and Tire Inflator

How to Use the ToughTested Phoenix Jump Starter and Tire Inflator

Learn how to jump start a car, inflate tires, charge devices, and use the LED work light with the ToughTested Phoenix Jump Starter, Tire Inflator & Power Bank Kit.

What the Phoenix Jump Starter & Tire Inflator Does

The ToughTested Phoenix Jump Starter, Tire Inflator & Power Bank Kit combines three essential roadside tools in one unit. It can start a gas engine up to 6 cylinders, inflate tires up to 150 PSI, charge your phone via USB, and light up a dark work area. This guide covers the supported functions so you can use each feature safely and effectively.

Jump Starting a Car with the Phoenix

The Phoenix delivers 500A starting current and 800A peak output, enough for most 4- and 6-cylinder gas engines. Follow these steps when you have a dead battery.

  1. Connect the jumper cables: Attach the red clamp to the positive terminal of the dead battery and the black clamp to a clean, unpainted metal surface away from the battery (engine block or chassis ground).
  2. Power on the jump starter: Press the power button on the Phoenix unit. The display or LED indicators should show readiness. If the unit has a boost mode, activate it only if the engine does not start immediately.
  3. Start the vehicle: Turn the ignition. If the engine does not start, wait before trying again. After the engine runs, disconnect the clamps in reverse order.

Using the 150 PSI Tire Inflator with Auto Stop

The built-in pump can inflate car, truck, SUV, and trailer tires. The auto-stop feature prevents over-inflation.

  1. Attach the hose: Screw the inflator hose onto the tire valve stem securely.
  2. Set your target pressure: Use the control buttons to set the desired PSI (e.g., 35 PSI for a typical passenger car tire). The auto-stop will shut off the pump when that pressure is reached.
  3. Start inflation: Press the start button. Monitor the pressure reading; the pump will stop automatically. Disconnect the hose and replace the valve cap.

Charging Devices with the 10W USB Port

The Phoenix includes a 10W USB charging port that can power a phone, tablet, or other small electronics. Connect your device’s charging cable to the USB output port on the unit. The battery capacity is sufficient for several phone top-ups, making it a useful backup power bank during an emergency or a road trip.

Using the 30-Lumen LED Work Light

A 30-lumen LED work light with multiple modes is built into the unit. Use it to illuminate the engine bay, tire area, or roadside at night. Cycle through modes (steady, strobe, or SOS) by pressing the light button. The light is modest but adequate for close-up tasks under the hood or by the tire.

Key Specifications at a Glance

Related Articles

Customer Service
Home
Products
Cart
Profile